Silicone Joint Sealant

    Cement based, Silicone Joint filler hard-to-contaminate, easy-to-clean, easily applicable, anti-mould, hygienic, flexible and high performance joint filling material with advanced water repellency which performs low water absorbency.APPLICATION AREASUsed to fill the joints of tile, ceramic, marble and other similar coatings in wet places such as bathrooms, kitchens, toilets as well water tanks, pools and terraces provided that they are not deeper than 6 mm.TECHNICAL PROPERTIESAccording to TS EN 13888 Fuga Europe Norm:Resistance to Abrasion                                 ≤1,000 mm³Reduced Water Absorption (after 30 minutes)     ≤2 gReduced Water Absorption (after 240 minutes)  ≤5 gPressure Strength                                           ≥ 15 N/mm²Bending Strength                                           ≥ 5 N/mm²Applicability period                                         Maximum 1 hourHardening time                                              12 hoursRequired time for surface to be opened to trafficMinimum 24 hoursAbove stated times are for an environment with 23±2 °C temperature and 50% ±5 humidity.Time periods get shorter in hotter environments and vice versa in colder environments.PROPERTIESUsed in joint intervals of 1-6 mm, resistant against water, good adherence, crack proof, stain proof.  It is also possible to color it with colors in ARS color scheme (only with 3-4-5 tones) approximately.
APPLICATIONDust, chippings and construction wastes which may be present in joint gaps should be removed with a wire brush before application.Add 6-7 lt water to a package of 20 kg and mix it.Rest the prepared mortar for 5 minutes and use it after mixing 1-2 minutes more.Apply the mortar by filling it in gaps as parallel and crosswise thoroughly using a plastic trowel.Remove the remaining mortar on surface with a moistened sponge thoroughly after 15-20 minutes according to the ambient temperature.Smoothen and gloss the surface with a wet cloth after the mortar gets dry.Points to take into account during application:-Application by adding water more than the specified quantity should be avoided as it will cause cracks, collapses and spalling.-Ambient temperature should be between +5 ℃ and +30 ℃.-It should not be applied on areas exposed to direct sun light.-Joint gaps should be moistened before application.CONSUMPTIONCeramic Size                       Joint Widths                       Consumption10 cm x 10 cm                  3 mm, 4 mm, 6 mm                    800 g/m2 , 1000 g/m2, 1500 g/m220 cm x 20 cm                  3 mm, 4 mm, 6 mm                    400 g/m2 , 500 g/m2, 750 g/m230 cm x 30 cm                  3 mm, 4 mm, 6 mm                    250 g/m2 , 300 g/m2, 500 g/m2Consumption values stated above are approximate values. Precise consumption will be known after completion of application as differences may occur according to gap structures.STORAGECan be stored approximately 6 months by its unopened package and in a dry place.PACKAGING20 kg.Kraft Bag